Martin RoboColor III Guia do Utilizador descarregar pdf (Página 8)

Link Configuration

This feature is used to make the product

configuration

, i.e. to configure which type of Units

you want to control on each of the eight controller channels. Please note that using this

feature

resets

the controller to the factory-default settings of

sequence number

show

number

and

trig rate

(please see the section named "Set Up". It may also be used to rescue

a controller whose information has been damaged in non vital areas (where the set-up

information is stored).

Please follow this procedure in order to make the

Configuration

1 Switch off the Martin 2308 controller, and then back on again.

2 After {robo} stops flashing, press [set up].

3 Channel (1) turns on and the display shows which type of Unit has been assigned to this

channel by displaying one of the following:

{1004} Roboscan 1004/1005/804/805

{805 } Do not use. Please note that 804/805 Units should be configured as

1004s

{1016} Roboscan 1016

{COL } Robocolor

{ZAP } Robozap

{0-10} Martin 516, 16 channel 0-10 V Dimmer Controller

{1408} Roboscan 1408

{ZAPII} Robozap MSR 1200

{P218} Roboscan Pro 218

{C200} Robocolor MSD 200

{COL2} Robocolor II

{CNTR} Centrepiece

{812 } Roboscan 812

{C400} Robocolor Pro 400

{518 } Roboscan Pro 518

NOTE Some of the products are supported by version 2.1 only and some only by

version 3.1. Please refer to table in the "Introduction".

4 You may now change the Unit type for this channel by using the joystick up or down, or,

[↑]or[↓] to browse through the supported Units.

5 Press [enter] to assign the Unit currently shown in the display. You will then be able to

configure channel 2. Repeat this process, selecting Unit and press [enter] until all 8

channels are set up.

6 After pressing [enter] for channel 8 the display will show {FAC }, at which point, the

controller will run a factory setting and then continue normal operation.

NOTE If you already have sequences programmed and you change the type of Unit

assigned to a channel your programs are likely to be unusable and you will need

to re-program.

Martin 2308 Controller Version 2.1/3.1 Page 9

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 60 61

Comentários a estes Manuais

Sem comentários

Martin RoboColor III Guia do Utilizador Página 8

Comentários a estes Manuais

Manuais e produtos relacionados com Holofotes Martin RoboColor III