Martin MAC III PERFORMANCE Manual do Utilizador

MAC III™ PERFORMANCEUSER MANUAL

10 MAC III Performance user manualLamp adjustmentWarning! Adjust the lamp with the fixture cool. The fixture may become hot during adjustment, so wea

DMX data link 11DMX data linkThe MAC III Performance has 5-pin locking XLR sockets for DMX and RDM input and output. The default pin-out on both sock

12 MAC III Performance user manualPhysical installationWarning! The MAC III Performance has a powerful pan motor. The torque reaction when the head i

Physical installation 132. Bolt each clamp securely to a clamp bracket with an M12 bolt (minimum grade 8.8) and lock nut.3. See Figure 6. Note the po

14 MAC III Performance user manualControl panel operationsYou can configure individual fixture settings such as the MAC III Performance’s DMX address

Control panel operations 15Battery powerThe display and control panel are powered by the MAC III Performance’s onboard battery. This gives access to

16 MAC III Performance user manualDMX addressing is limited to channels 1 - 478 in 16-bit mode and 1 - 472 in 16-bit extended mode. The upper limit m

Control panel operations 17Pan range for pan limit purposes runs from 0° to 360° clockwise as seen looking at the fixture from the bottom of the base

18 MAC III Performance user manualForced sets all fans to 100% speed until another FAN CLEAN MODE setting is selected.This feature does not eliminate

Control panel operations 19• ERROR MODE enables or disables error warnings. If set to Start, the display is activated and lights up if the fixture ne

DimensionsAll measurements are expressed in millimetersThe minimum center-to-center distance can be reduced if pan limits are set via the control menu

20 MAC III Performance user manualDMX signal monitoringThe MAC III Performance provides data on the DMX signal it is receiving in the DMX LIVE menu.

Adjusting settings via DMX 21Adjusting settings via DMXCertain fixture settings and parameters can be adjusted from the DMX controller on DMX channel

22 MAC III Performance user manual• Zoom/focus linking• Pan/tilt limits• Calibration offsetsDefining calibration offsets via DMXThe ”Fixture adjustme

Effects 23EffectsThis section gives details of the effects that can be controlled via DMX. See “MAC III Performance DMX protocol” on page 47 for deta

24 MAC III Performance user manualfirst channel, the indexed angle or rotation speed are set on the next channel. If gobo indexing is selected on the

Effects 25Animation wheelThe MAC III Performance is supplied with the “Tribal waves” gobo animation wheel (P/N 62325143) installed. See under “Specif

26 MAC III Performance user manualPan and tiltCoarse and fine pan and tilt control are available in both 16-bit and 16-bit extended modes.Maximum and

Effects 27Followspot modeThe MAC III Performance fixture software from version 1.6.0 features a followspot mode in which the fixture ignores any pan,

28 MAC III Performance user manual• Whatever type of screw used, the portion of the screw that goes into the rear head cover must have a length of be

RDM 29RDMThe MAC III Performance can communicate using RDM (Remote Device Management) in accordance with ESTA’s American National Standard E1.20-2006

ContentsSafety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

30 MAC III Performance user manualMAC III Performance supported standard commandsGETallowedSETallowed RDM parameter ID’s (slot 21-22) NotesCategory –

RDM 31RDM accessible onboard sensorsThe following onboard sensors are RDM accessible:MAC III Performance supported manufacturer specific commandsFAN

32 MAC III Performance user manual99FOLLOW_SPOT_MODE9 FOLLOW_SPOT_MODE_LOCK_TOGGLE99FOLLOW_SPOT_MODE _LOCK_PAN99FOLLOW_SPOT_MODE _LOCK_TILTFixture co

Service and maintenance 33Service and maintenanceWarning! Disconnect the fixture from power and allow to cool for 2 hours 45 minutes before removing

34 MAC III Performance user manualEvent logThe MAC III Performance from software version 1.5.0 monitors performance, any errors or warnings, temperat

Service and maintenance 354. Connect the USB memory device to a PC. Logs are stored in the root directory of the memory device in a folder called EVE

36 MAC III Performance user manual• Fixture Information displays data from the fixture’s timers when it was last powered up.• Module Information disp

Service and maintenance 37The example below in the Dynamic Content section, shows temperature data for the different sensors in the fixture. In the e

38 MAC III Performance user manual4. Make sure that you are ready for the head to move, then press the Escape button to exit pan/tilt sensor calibrat

Service and maintenance 397. Reconnect the data link.Zoom-focus linking is reset to default (medium distance) when new software is uploaded. Other fi

Lubrication . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

40 MAC III Performance user manualCleaning and replacing the air filtersThe item AIR FILTERS in the FIXTURE INFORMATION menu is intended to be used t

Service and maintenance 41Cleaning the fixtureTo clean the head:1. Disconnect the fixture from power and allow the components to cool for 2 hours 45

42 MAC III Performance user manualGobos in the MAC III PerformanceThe MAC III Performance uses specially-designed borosilicate 3.3 gobos with a heavy

Service and maintenance 43Replacing rotating gobosImportant! The gobo can fall out if the spring is inserted backwards.Do not lubricate gobo bearings

44 MAC III Performance user manualGobo orientationThe orientations shown in Figure 23 are correct in most cases, but consult your Martin dealer or go

Service and maintenance 45Replacing the gobo animation wheelImportant! The gobo animation wheel is glass and must be handled gently. Do not attempt t

46 MAC III Performance user manualRemoving modulesThe MAC III Performance is modular in design. A full procedure for removing and servicing effect mo

MAC III Performance DMX protocol 47MAC III Performance DMX protocolAvailable in software 1.6.0 or laterBasic 16-bit Mode16-bit Extended ModeDMX Value

48 MAC III Performance user manual560 - 25501 - 127128 - 2542550 - 10001 - 5051 - 99100YellowWhite → full yellowYellow range in random CMY colorwhen

MAC III Performance DMX protocol 49890 - 910 - 1415 - 1920 - 2425 - 2930 - 3435 - 3940 - 4445 - 4950 - 5455 - 5960 - 8990 - 119120 - 149150 - 179180

Safety Information 5Safety InformationThe following symbols are used to identify important safety information on the product and in this manual:This

50 MAC III Performance user manual17 180 - 255 0 - 100Framing blade 4, positionOut → in18 190 -126127 - 128129 - 2550 - 495051 - 100Framing blade 4,

MAC III Performance DMX protocol 5121 250 - 1819 - 5758 - 8384 - 109110 - 135136 - 207208 - 2550 - 67 - 2223 - 3233 - 4243 - 5253 - 8283 - 100Color/C

52 MAC III Performance user manual28 330 - 255 0 - 100Zoom (MSB)Flood → spot -340 - 255 0 - 100 Zoom, fine (LSB)29 350 - 255 0 - 100Pan (MSB) Left →

MAC III Performance DMX protocol 5333 390 - 910 - 1415 - 1920 - 2425 - 2930 - 3435 - 3940 - 4445 - 4950 - 5455 - 5960 - 6465 - 6970 - 7475 - 7980 - 8

54 MAC III Performance user manualMSB = Most significant byteLSB = Least significant byte34 400 - 3940 - 4445 - 4950 - 5455 - 5960 - 6465 - 6970 - 74

Control panel menus 55Control panel menusCommands marked * can also be executed via DMXMenu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Def

56 MAC III Performance user manualPERSONALITY(continued)FANSLAMP COOLING50%Sets lamp cooling fans to 50% capacity (color temperature of light output

Control panel menus 57PERSONALITY(continued)PARAMETER SHORTCUTSOffEffects avoid open positions during effects changesOnEffects take shortest route du

58 MAC III Performance user manualFIXTURE INFORMATION(continued)FAN SPEED Displays speed in RPM of all cooling fansTEMPERATUREDisplays temperature in

Service and display messages 59Service and display messagesThe MAC III Performance gives service and maintenance information by displaying a large 3-

6 MAC III Performance user manualLAMP SAFETY• Prolonged exposure to an unshielded discharge lamp can cause eye and skin burns. Do not stare directly

60 MAC III Performance user manualCDPT CALIBRATE DATA PAN/TILTUnable to read/write data to external eeprom board (Calibrate Data) on Yoke. The PCB ne

Service and display messages 61FAN LAMP L FAN ERRORFAN BOTTOM FAN ERRORFAN CMY FAN ERRORFAN TOP FAN ERRORFAN MAINBOARD FAN 1ERRORFAN POWER FAN 1 ERRO

62 MAC III Performance user manualLSER LAMP SENSING CIRCUIT ERROR (s/w versions from ver. 1.3)Lamp sensing circuit reports that lamp should be on but

Service and display messages 63UPLD DMX UPLOAD ERRORAn error occurred during upload via DMX. Check cabling and connections, and then restart.UPLD DMX

64 MAC III Performance user manualTroubleshooting Problem Probable cause(s) RemedyOne or more of the fixtures is completely dead.No power to fixture.

Specifications 65SpecificationsPhysicalLength . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

66 MAC III Performance user manualStandard lens, zoom at median Efficiency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Specifications 67ThermalMaximum ambient temperature (Ta) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40° C

Disposing of this productMartin™ products are supplied in compliance with Directive 2002/96/EC of the European Parliament and of the Council of the Eu

Introduction 7IntroductionThank you for selecting the Martin™ MAC III Performance™. This moving-head spotlight features:• 1500 Watt short-arc high-ou

www.martin.com • Olof Palmes Allé 18 • 8200 Aarhus N • DenmarkTel: +45 8740 0000 • Fax +45 8740 0010

8 MAC III Performance user manualAC powerWarning! For protection from electric shock, the fixture must be grounded (earthed). The AC mains supply mus

Lamp 9LampAbout the discharge lampThe MAC III Performance is designed for use with an Osram HTI 1500W/60/P50 lamp. This highly efficient double-ended