Martin Atomic Colors Manual do Utilizador

Atomic Colors user manual

System Connections This section describes how to connect the Atomic Colors to your lighting system using a 2-unit or an 8-unit external power supp

MPU-02 Connection Procedure 1. Rig the combined Atomic 3000 DMX and Atomic Colors fixture in the desired position, ensuring that you use the safe

MPU-08 Connection procedure Important Note: ‘Return’ lines The MPU-08 is designed for use with larger quantities of Atomic Colors fixtures, and

System connection diagram using the MPU-08 power supply (For clarity, only the Atomic Colors are sh

OPERATING THE UNIT 6 All user settings are accessed using the LED display and the three push buttons on the side panel. Poweri

Monitor Display If left undisturbed for 5-7 seconds, the display will revert to ‘Monitor Mode’ The left hand vertical bar indicates that there

Unit settings: Note: After changing any of the settings, press ‘ACTION/RECALL’ to store the new value. DMX address Selects the unit’s DMX addres

Factory settings To restore factory default settings, press and hold the ‘ACTION/RECALL’ button and press the ‘UP’ button for 1 second. The ‘F

Summary of control functions: Setting Description Actions required Display DMX address Sets the unit’s DMX address Press ‘UP’ or ‘‘DOWN’ once to

Programming notes: The Atomic Colors uses 1 or 2 DMX channels, depending on which control mode it is set for. The first DMX channel (start channel) c

Atomic Colors Unit Atomic 3000 DMX and Atomic Colors Unit combined. © 2003 Martin Professional A/S, Denmark. All rights reserved. No part of th

Introduction The unit comes supplied with a gel string installed. This gel string has 10 separate color filters joined with special high temperature

6. Rotate whole the unit so that the motor/fan/ electronics section on your right-hand side. Place the gel tab beside the anchor on the other shaft (S

Installation of a gel string Atomic Colors User Manual Changing the gel string 22

Gel string construction Atomic Colors User Manual Changing the gel string 23

Problem Troubleshooting SERVICE 7 Troubleshooting is a process of elimination. First, rule out the other field factors (i.e. faulty cables, power

Physical Size: 470 x 273 x 102 mm (18.5 x 10.7 x 4.0 in.)Weight: 2.5 kg (5.6 lb) Thermal Max. ambient temperature 40° C (104° F)Cooling 3 va

SAFETY INFORMATION... 4 INTRODUCTION... 5

SAFETY INFORMATION 1 Warning: This product is for professional use only! It is not designed for household use. This product is desig

Atomic Colors User Manual Introduction 5 The Atomic Colors is a dedicated add-on unit for the Martin Atomic 3000 DMX strobe

Unpacking The Atomic Colors comes with the following items: • 5 M (16.4 ft) XLR-4 connecting cable • Standard gel string (factory installed) •

Control data Any device that outputs the DMX512 (1990) data protocol (including the one that may already be controlling your Atomic 3000 DMX strobe) c

XLR-4 Cable Construction Notes: • It is very important to ensure that the drain wire from the cable shield is connected to both XLR connector case

MOUNTING THE UNIT 4 1. Place the Atomic 3000 DMX unit so that it is resting on its bottom edge as shown below. 2. Using an 8mm AF wrench, caref