Martin Atomic Colors Manual do Utilizador descarregar pdf (Página 8)

XLR-4 Cable Construction

Notes:

• It is very important to ensure that the drain wire from the cable shield is connected to both

XLR connector cases.

• Damage will occur if power connections short to the data, ground, or shield connections.

• When assembling XLR 4-pin cables, heat shrink should be used on each individual pin to

prevent short circuits. (See diagram below)

• Please take care when constructing these cables. A high percentage of problems are a direct

result of poor cable construction.

Detail of connector wiring (typical)

The correct wiring between male and female connectors is ‘one to one’.

XLR-4

Connector

(Pin No.)

Function Minimum Cable size

1 Ground (0 V) 2.50mm² (14 AWG)

2 Control data minus (-) 0.35mm² (22 AWG)

3 Control data plus (+) 0.35mm² (22 AWG)

Twisted data pair, with foil

shield and drain wire.

4 24 VDC (+ve) 2.50mm² (14 AWG)

Chassis Cable shield/Drain wire 0.25mm² (24 AWG)

(See above)

Atomic Colors User Manual Preparation for use 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 24 25

Sem comentários

Martin Atomic Colors Manual do Utilizador Página 8