Martin Atomic Colors Manual do Utilizador descarregar pdf (Página 12)

MPU-08 Connection procedure

Important Note: ‘Return’ lines

The MPU-08 is designed for use with larger quantities of Atomic Colors fixtures, and

in bigger installations where the cable runs a longer.

In order to reduce the voltage drop in these longer cable runs, an XLR-4 ‘Return’

cable must be installed in the s

stem, so the cablin

forms a continuous loo

1. Rig the combined Atomic 3000DMX and Atomic Colors fixtures in their desired

positions, ensuring that you use the safety wire as a secondary means of attachment.

2. Connect your source of DMX data to the XLR-5 input socket on the front of the MPU-08.

3. Using an XLR-4 cable, connect the ‘out’ of ‘Power outlet 1’ on the MPU-08, to the XLR-

4 input on the Atomic Colors fixture #1.

4. Using another XLR-4 cable, connect the XLR-4 output of Atomic Colors fixture #1, to

the XLR-4 input on the Atomic Colors fixture #2.

5. Repeat step 4, until you have a maximum of four Atomic Colors fixtures connected

together.

6. Connect the XLR-4 output on the last Atomic Colors fixture to the ‘Return’ of ‘Power

outlet 1’ on the MPU-08.

7. Repeat steps 3-6 using cables and fixtures connected to ‘Power outlet 2’ on the MPU-08,

8. Connect the AC supplies to the MPU-08 and the Atomic 3000DMX unit(s).

Note: Proper connection of the units to the power supply is important!

Please follow these basic rules.

• Use the proper type of cable and connectors.

• Keep cable runs as short as possible, to reduce line loss.

• The total cable length for run should not exceed 75 M (245 ft), including the return line.

• Always use a return cable for each cable run. This will ensure balanced LV power to all

units.

•

Before operating the Atomic strobe, make sure the power supply for the Atomic Colors

is connected, and switched on.

Atomic Colors User Manual Connecting the unit 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 24 25

Sem comentários

Martin Atomic Colors Manual do Utilizador Página 12