Martin RoboColor III Especificações

RoboColor Pro 400users guideUser.fm Page 1 Monday, April 17, 2000 11:22 AM

10 ABOUT FAN CONTROLBeginning with CPU firmware version 6.5, fan control is completely automatic. Thefan operates as follows:• Fan speed is automatica

11DMX PROTOCOL6DMX Mode PL11 Jumper Location ChannelsMode 1: Tracking (DEFAULT)No jumper 5 Mode 2: Vector Pin 4 and 5 7 Mode 3: Tracking + Lamp Off vi

12*DMX fan control is not available with CPU firmware version 6.5.30265278104130156157-171172-185186-199200-214215-227228-241242-255010203141516162 -

13SERVICE7This section describes how to adjust the lamp for best performance and how tochange the default DMX mode setting. Refer all other service to

14 DMX MODE SETUPThe DMX mode is selected with a jumper on the main circuit board inside thefixture. The factory default is DMX mode 1. 1 Disconnect t

15SPECIFICATIONS8Length incl./excl. bracket ... 306 mm (12.0") / 306 mm (12.0")Width incl./excl. bracket..

INTRODUCTION. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

3INTRODUCTION1Congratulations on your choice of the RoboColor Pro 400, a professional highperformance, intelligent lighting projector that features:•

4SAFETY2Warning! This product is for professional use only. It is not for household use.This product presents risks of lethal or severe injury due to

5To protect yourself and others from burns and fire• Never attempt to bypass the thermostatic switch or fuses. Always replace defective fuses with one

6INSTALLATION3The RoboColor Pro 400 package includes mounting bracket and fittings, 3-pin XLRdata cable, mains cable, and this users guide. The fixtur

7STAND-ALONE OPERATION4The RoboColor Pro 400 may be operated in stand-alone mode without a controller.Music-trigger uses a built in microphone for sou

8CONTROLLER OPERATION5The RoboColor Pro 400 accepts two control protocols: Martin RS-485 and DMX512. CONNECTING THE SERIAL DATA LINKThe RoboColor Pro

9 ADDRESS SETTINGThe DIP-switch on the rear panel is used to select the control address on which theRoboColor Pro 400 responds to the controller. The