Martin RoboColor III Guia do Utilizador descarregar pdf (Página 19)

Music trig

The

music trig

mode requires a line level signal (775mV RMS) to be connected to the 6mm

jack-socket in the rear of the controller.

The input signal sensitivity may be adjusted by pressing [level] and then [↑] to increase or

[↓] to decrease the sensitivity level. The new level setting takes effect immediately. The

joystick up - down may also be used to select level. You may select levels from 1 to 20.

Press [level] again to leave the level setting function. You have to leave level setting mode

to return to normal operation.

If (auto) is enabled while (music) is on, a special function is obtained:

If the music signal stops for 2-3 seconds the

autotrig rate

will take over until a new music

signal is detected.

Follow-spots

To use one or more Units as follow spots while a

show

sequence

is running press [1] -

[8] to select the Unit(s) to be used. (1) - (8) will be turned on accordingly. It is not possible

to select two different types of Units at the same time. If you try to do this anyway, the

controller turns off the channel(s) not frozen, and turns on the last one you selected. Now

you have control of the unit(s) and may use the control keys to change position, color, gobo

etc..

Frozen-mode

When the mirror(s) have been moved to a selected spot you may freeze the position by

pressing [1] - [8]. (1) - (8) will start flashing to indicate the frozen state. To disable this

function press [1] - [8] again and they will return to normal run mode.

On-Line

Pressing [on line], so that (on line) turns off, disables

communication

between the controller

and the Units, switches off the Units’ lights and disables the trigging. If you have a RoboZap

connected, and the mirror is rotating, this is stopped. Pressing [on line] again re-enables the

communication

and trigging and turns on the lights that were switched on before.

Page 20 Version 2.1/3.1 Martin 2308 Controller

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 60 61

Sem comentários

Martin RoboColor III Guia do Utilizador Página 19