Martin RoboColor III Guia do Utilizador descarregar pdf (Página 20)

Special functions

Initialization

Only use this feature when it is absolutely essential as it will entirely erase all information

about

shows

and

sequences

in memory. However, this is the only way to regain control of

your controller when information about

sequences

is too damaged to be restored in the

usual way.

Use this function only if you really want to erase all

sequence

information as the controller

will be returned to the state it was in when you first purchased it.

The procedure is as follows:

1 Switch off the controller then switch it back on.

2 Wait until {robo} has stopped flashing.

3 Press [level], [on line] and [setup] at the same time and keep them down.

4 The display shows { In }.

5 Press [enter] to erase all memory, or turn the controller off, and then back on if you

wish to cancel.

Write-protecting the memory

If you want to prevent unauthorized personnel from overwriting the memory contents in your

2308 controller you may write-protect the memory. Unplug the controller from the mains and

remove the jumper labelled ’SEQ STORE ENABLE’ located at the top edge of the front

PCB.

The 2308 Controller will give a warning when trying to save data to a write-protected

memory. If the memory is write-protected the controller will display a {-Pr-}, thereby giving

warning when entering Edit Seq or Edit Show modes. It will also warn if you try to save

other information such as setup or configuration. To clear the warning message press

[enter].

Using external joystick

By connecting an external joystick (standard digital or micro-switch type) you may duplicate

the functions of the built-in joystick as well as some of the functions from the front panel

(

gobo

color

shutter

and

speed

). The functions which are duplicated depend on the exact

connection of the joystick to the controller. The label on the rear of the controller shows how

to connect the external joystick.

Transferring data from one Controller to another

In order to transfer (copy) data from one controller to another please note that both

controllers MUST have at least software version 2.0 and they MUST have the same memory

installed in them (eg. 611 scenes).

In the following the term

upload

is used to describe the process of transferring data from a

source controller and

download

describes the process of receiving data to a target

Martin 2308 Controller Version 2.1/3.1 Page 21

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 60 61

Comentários a estes Manuais

Sem comentários

Martin RoboColor III Guia do Utilizador Página 20

Comentários a estes Manuais

Manuais e produtos relacionados com Holofotes Martin RoboColor III