Martin CX-2 Manual do Utilizador descarregar pdf (Página 8)

8 AC power connection CX-4 user manual

POWER

CONNECTION

The CX-4 power supply must be wired to the voltage and frequency setting that

most closely matches the local AC supply. The factory setting is shown on the

serial number label.

Warning! For protection from fire and electric shock, the fixture must be

grounded (earthed). The power supply shall have overload and

ground-fault protection.

Warning! Verify that the feed cables are undamaged and rated for the

current requirements of all connected devices before use.

Important! Check the power supply setting before applying power.

Important! Do not connect the fixture to a dimmer system.

To install a plug on the mains lead

The mains lead must be fitted with a grounding-type cord cap that fits your

power distribution system. Consult a qualified electrician if you have any

doubts about proper installation.

• Following the cord cap manufacturer’s instructions, connect the yellow and

green wire to ground (earth), the brown wire to live, and the blue wire to

neutral. The table below shows some pin identification schemes.

Wire Pin Marking Screw color

brown live “L” yellow or brass

blue neutral “N” silver

yellow/green ground green

Table 1: Cord cap wiring

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Sem comentários

Martin CX-2 Manual do Utilizador Página 8