Martin CX-2 Manual do Utilizador descarregar pdf (Página 16)

16 DMX operation CX-4 user manual

DMX

OPERATION

DMX MODES

The CX-4 has 2 DMX modes to choose from: a 1-channel mode that provides

control of the built-in stand-alone features, and a 6-channel mode that provides

full control of all effects.

The 6-channel mode provides 2 options for controlling the effect wheel that are

selected with DIP-switch 12.

To select DMX mode

1 Disconnect the fixture from power.

Set DIP-switch pin 10 to OFF.

2 To select 1-channel DMX mode, set DIP-switch pin 11 to ON. To select 6-

channel DMX mode, set DIP-switch pin 11 to OFF

3 Select the effect wheel control option. Set DIP-switch pin 12 to OFF if you

want the effect wheel to be open at DMX values 0 - 9. Set it to ON if you want

the gobo wheel to blackout the light at DMX 0 - 9.

DMX ADDRESS

DIP-switch pins 1-9 are used to set the control address. The address, also known

as the start channel, is the first channel used to receive instructions from the

controller.

For independent control, each fixture must be assigned its own address and non-

overlapping control channels. Two CX-4s may share the same address only if

they are to respond identically: they will receive the same instructions and

individual control will not be possible.

To set the DMX address

1 Select an address for the fixture on your controller. Look up the DIP-switch

setting for the address in the table below.

2 Disconnect the fixture from power.

3 Set pins 1 through 9 to the ON (1) or OFF (0) position as listed in the table.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sem comentários

Martin CX-2 Manual do Utilizador Página 16