Martin RoboColor III Manual do Utilizador descarregar pdf (Página 17)

User Manual Service and Maintenance 17

To replace the secondary fuse

1 Access the circuit board as described earlier.

2 Replace the fuse with one of the same size and rating.

DMX MODE

• You can switch between DMX modes 1 and 2 by setting or removing the

jumper between pin 1 and 2 on PL113 as shown.

CPU SOFTWARE

The RoboColor III control software can be updated when new features become

available. Software can be supplied by your Martin dealer as P/N 62122026.

Please check with your Martin dealer to find out if the software upgrade requires

any mechanical changes to the RoboColor III system.

To update software

Important! To avoid damaging the CPU by electrostatic discharges, touch the

heat sink of the voltage regulator (IC102) before and when removing

or inserting the CPU.

1 Access the circuit board as described earlier.

2 Remove the existing CPU (IC101) from the PCB.

F202, 3.15AT/250V (slow blow)

PL113

Set jumper between

pin 1 and 2 to

enable extended

DMX mode

(mode 2).

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Sem comentários

Martin RoboColor III Manual do Utilizador Página 17