Martin Ego 01 Manual do Utilizador descarregar pdf (Página 6)

6 Ego user manual

• Provide a minimum clearance of 0.1 meters (4 inches) around fans and air

vents.

• Replace the lamp if it becomes defective or worn out, or before usage

exceeds the maximum service life. When replacing the lamp, allow the

fixture to cool for at least 5 minutes before opening the fixture or removing

the lamp. It can take up to 15 minutes for the fixture to cool completely.

• Never place filters or other materials over the lens or mirror drum.

• The exterior of the fixture can become hot. Allow the fixture to cool for at

least 5 minutes before handling.

• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C

(104° F).

• Do not stare directly into the light.

• Never operate the fixture without all lenses and covers installed: an

unshielded lamp emits dangerous UV radiation that can cause burns and

eye damage.

Preventing injuries due to falls

• When suspending the fixture above ground level, verify that the structure

can hold at least 10 times the weight of all installed devices.

• Verify that all external covers and rigging hardware are securely fastened

and use an approved means of secondary attachment such as a safety

cable.

• Block access below the work area whenever installing or removing the

fixture.

UNPACKING

The packing material is carefully designed to protect the fixture during

shipment - always use it to transport the fixture.

The Ego comes with the following:

• 3-meter, 3-wire IEC power cable

• User manual

1 2 3 4 5 6 7 8 9 10 11 ... 18 19

Sem comentários

Martin Ego 01 Manual do Utilizador Página 6