Martin Ego 01 Manual do Utilizador descarregar pdf (Página 16)

16 Ego user manual

3 If replacing a lamp, grasp the old

lamp by the reflector and pull it out

of the holder. Then pull the socket

off the lamp. Do not pull the wires.

4 Push the socket fully onto the pins

of the new lamp.

5 Clean the glass bulb with the cloth

supplied with the lamp, particularly

if your fingers touched the glass. A

clean, lint-free cloth wetted with

alcohol may also be used.

6 Gently push the lamp into the

holder until it snaps into place.

7 Replace the fixture cover and

tighten the access screws, taking

care not to trap any loose wires.

FUSES

The Ego uses a time-delay fuse for protection against current overload.

An indication that the fuse may have blown is that when power is applied

the lamp does not light and the fan does not operate.

If the fuse blows repeatedly, there is a fault with the unit that requires

service by a Martin technician.

Never bypass the fuse or replace it with one of another size or rating.

Replacing the main fuse

1 Unplug the mains cable from the

input socket.

2 Remove the six access screws from

the cover and lift it off

3 The fuse can be found on the circuit

board, a diagram of which can be

found on the inside of the fixture

cover. Use this to locate the fuse.

4 Remove the fuse and replace the

fuse with one of the same type. The

fuse rating is listed on the serial

number label that can be found on

the back of the fixture.

1 2 ... 11 12 13 14 15 16 17 18 19

Sem comentários

Martin Ego 01 Manual do Utilizador Página 16