Martin MX SERIES Manual do Utilizador descarregar pdf (Página 16)

DMX operation

To select DMX mode

1 Disconnect the fixture from power.

Set DIP-switch pin 10 to OFF.

2 To select 1-channel DMX mode, set DIP-switch pin 11 to ON.

3 To select 6-channel DMX mode, set DIP-switch pin 11 to OFF. Verify that the 6/7

ch. jumper is set for 6 channels. This is the factory configuration. See “Setting

the 6/7-ch. DMX jumper” on page 21.

4 To select 7-channel DMX mode, set DIP-switch pin 11 to OFF. Set the 6/7 ch.

jumper for 7 channels as described on page 21.

DMX ADDRESS

The DMX address, also known as the start channel, is the first channel used to

receive instructions from the controller. It is set using the DIP-switch.

For independent control, each fixture must be assigned its own address and non-

overlapping control channels. Two MX-4s may share the same address only if they

are to respond identically: they will receive the same instructions and individual

control will not be possible.

Pin 12 is reserved for future use and currently has no function.

To set the DMX address

1 Select a DMX mode as described above.

2 Select a DMX address for the fixture on your controller.

3 Look up the DIP-switch setting for the address in Table 5.

4 Set pins 1 through 9 to the ON (1) or OFF (0) position as listed in the table.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Sem comentários

Martin MX SERIES Manual do Utilizador Página 16