Martin CX-2 Manual do Utilizador descarregar pdf (Página 6)

6 Lamp installation CX-2 user manual

AMP

INSTALLATION

The CX-2 uses a 24V, 250W ELC halogen lamp. Two models are available, an

economical 300 hour lamp from Philips and a high-output 50 hour lamp from

Osram. Installing any other lamp may damage the fixture.

Allow the lamp to cool for at least 5 minutes before packing and moving the

fixture. To avoid possible damage, remove the lamp when shipping the fixture.

To install a lamp in the CX-2

Warning! Always disconnect the

fixture from AC power

and allow the fixture to

cool for 5 minutes

before installing a new

lamp.

1 Disconnect the fixture from

AC power. If replacing a hot

lamp, allow it to cool for 5

minutes before removing the

cover. The lamp cools faster

with the cover in place.

2 Release the 4 cover locks by

turning them a quarter-turn

counterclockwise. Lift the cover straight off.

3 To remove the lamp, grasp it by the reflector and pull it out of the holder. Pull

the socket straight back off the metal pins. Do not pull the wires.

4 Push the socket fully onto the pins of the new lamp.

5 Gently push the lamp into the holder until it snaps into place.

6 Replace the top cover. To lock the 4 cover locks, turn them a half to a quarter

turn clockwise until you feel them click.

Do not overtighten

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Sem comentários

Martin CX-2 Manual do Utilizador Página 6