Martin CX-2 Manual do Utilizador descarregar pdf (Página 12)

12 DIP-switch settings CX-2 user manual

SPECIAL SETTINGS

DIP-switch pins 1 - 9 are used to select special options in stand-alone and

master/slave mode.

To enable these options, pin 10 must be ON.

Pin 11 toggles between 1 and 4 channel DMX control. It must be OFF for

master/slave operation.

Lamp life can be extended by reducing the voltage slightly. Set DIP-switch pin 12

to ON for longer lamp life, or OFF for full output intensity.

Note: the fixture shall be disconnected from AC power when changing DIP-switch

settings. Changes take effect after the fixture has been turned off.

Important! Pin 10 must be ON to enable special settings on pins 1 - 9.

Pin Setting Effect

1 ON Music trigger

OFF Automatic trigger

2 ON Stand-alone mode on, single or master fixture

OFF Stand-alone mode off / slave fixture

3 ON Test program for service use

OFF Normal operation

4 ON Slow color and gobo change

OFF Fast color and gobo change

5 ON No effect

OFF No effect

6 ON Random slave color wheel position (set on slave fixture)

OFF Slave color wheel position same as master

7 ON Random slave gobo wheel position (set on slave fixture)

OFF Slave gobo wheel position same as master

8 ON Invert slave color wheel position (set on slave fixture)

OFF Slave color wheel position same as master

9 ON Invert slave gobo wheel position (set on slave fixture)

OFF Slave gobo wheel position same as master

10 ON Enable special settings with pins 1 - 9

OFF Enable DMX address with pins 1 - 9

11 ON 1-channel mode on

OFF 1-channel mode off

12 ON Reduced power / longer lamp life

OFF Full power / maximum intensity

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

Sem comentários

Martin CX-2 Manual do Utilizador Página 12