Martin CX-2 Manual do Utilizador descarregar pdf (Página 10)

10 DIP-switch settings CX-2 user manual

DIP-

SWITCH

SETTINGS

This section describes how to select the DMX address and special settings using

the DIP-switch on the end panel.

Important! Disconnect the fixture from AC power before changing the

DIP-switch setting. Changes take effect after the fixture has

been turned off and back on.

DMX ADDRESS SELECTION

If the CX-2 is to be used with a DMX protocol controller, then the DIP-switch

must be set to a DMX control address. The address, also known as the start

channel, is the first channel used to receive instructions from the controller. The

CX-2 uses 4 channels for full DMX operation. For independent control, each

fixture must be assigned its own address and non-overlapping control channels.

Two CX-2s may share the same address only if they are to respond identically:

they will receive the same instructions and individual control will not be possible.

To set the DMX address

1 Select an address for the fixture on your controller.

2 Look up the DIP-switch setting for the address on page 11.

3 Disconnect the fixture from AC power.

4 Set pins 1 through 9 to the ON (1) or OFF (0) position as listed in the table.

5 Set pin 10 to the OFF position.

6 Set pin 11 to the OFF position for full 4-channel DMX operation or to the ON

position for 1-channel DMX operation.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Sem comentários

Martin CX-2 Manual do Utilizador Página 10