Martin EFX800 Manual do Utilizador descarregar pdf (Página 17)

Operation 17

Operation

Getting started

Mania EFX fixtures are supplied in DMX mode with DMX address set to 1.

If you want to operate a fixture without a DMX controller, you need to set it

to music trig or auto trig mode before use (see “Selecting DMX, music trig

or auto trig operating modes” on page 18).

Powering on

Once the fixture is correctly and safely installed, power on at the fixture’s

power on/off switch. The fixture will start up and reset.

If the fixture resets successfully, the software version installed will appear

in the fixture’s display. For example, if software version 1.00 is installed,

the message

100 should appear in the display.

Once the fixture has reset, the fixture will display either its DMX address,

901 (music trig mode) or 900 (auto trig mode).

If any other message is displayed, the fixture has detected an error (see

“Error messages” on page 25). If this occurs, switch off, wait a few

seconds and switch on again. If the error message appears again, consult

your Martin dealer.

Music trig, auto trig and DMX

modes

Mania EFX fixtures have three main operating modes:

Music trig mode: In this mode, lighting effects are triggered by music

intensity. Multiple fixtures can be synchronized if one master fixture is set

to music trig mode and the other fixtures are set to DMX mode.

Auto trig mode: In this mode, the fixture runs a factory-set dynamic light

show that uses all the fixture’s effects in a random program. Multiple

fixtures can be synchronized if one master fixture is set to auto trig mode

and the other fixtures are set to DMX mode.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Sem comentários

Martin EFX800 Manual do Utilizador Página 17