
MX-1 user manual DMX operation 17
1-CHANNEL DMX OPERATION
The functions shown in the following table are available in 1-channel mode.
When a “stand-alone” function is selected, the fixture steps through a routine
using a built-in microphone to trigger the action to the beat of the music. Note
that multiple fixtures cannot be synchronized in this mode.
6/7-CHANNEL DMX OPERATION
The 6 and 7 channel modes provide all functions listed in the DMX protocol on
page 21.
Channel 1 controls the light intensity and the strobe rate. It also allows you to
execute a “stand-alone” program with random pan/tilt movement using automatic
or music trigger. The fixture can also be reset from the controller on channel 1.
Channel 2 is not used by the MX-1.
Channel 3 controls the position of the color/gobo effect wheel. When set to 100
percent, the wheel moves to random positions using the trigger selected on
channel 1.
Mirror pan and tilt are controlled on channels 4 and 5.
Channel 6 controls pan and tilt speed, allowing you to vary the movement speed
on controllers without cross-fader. If your controller has cross-faders, and you
use them, then set channel 6 to the “tracking” speed (0 percent).
Channel 7 provides speed control of the effect wheel, allowing you to program
slow transitions from one effect to another.
DMX value Percent Function
0 - 10
11 - 20
21 - 80
81 - 115
116 - 140
141 - 175
176 - 210
211 - 255
0 - 4
5 - 7
8 - 31
32 - 45
46 - 55
56 - 68
69 - 82
83 - 100
Blackout (light off)
Open (light on)
Strobe
Stand-alone with slow music trigger
Stand-alone with medium music trigger
Stand-alone with fast music trigger
Stand-alone with random music trigger
Manual trigger area, crossover at 240 (94%)
Comentários a estes Manuais