Martin EFX800 Manual do Utilizador descarregar pdf (Página 19)

Operation 19

Setting up synchronized operation

To set up fixtures for synchronized operation:

1. Ensure that all fixtures on the data link are in DMX mode.

2. Select one fixture to be the master and set it to auto trig or music trig

mode (see “Selecting DMX, music trig or auto trig operating modes” on

page 18)

3. When a slave fixture receives signals from the master, it will

automatically begin operating in slave mode.

910 will appear in its

display and the green Data LED will light to show that the fixture is

receiving control data.

Fixtures return to their DMX/auto trig/music trig settings when powered off

and on, so you should only need to set fixtures as masters/slaves once.

DMX controller operation

Setting DMX mode 1 or 2

Two DMX modes are available: DMX mode 1 (normal) and DMX mode 2

(extended). Mode 2 uses two extra DMX channels that allow you to select

pre-programmed macros and set the speed of effects movement from the

DMX controller. The fixture is supplied set to DMX mode 2.

• The EFX500 uses seven DMX channels in DMX mode 1 and nine

channels in DMX mode 2.

• The EFX600 uses six DMX channels in DMX mode 1 and eight

channels in DMX mode 2.

• The EFX700 uses four channels in DMX mode 1 and six channels in

DMX mode 2.

X100 X10 X1 Mode

DMX Address

Data LED lit

Slave mode

[Mode] button

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 55 56

Sem comentários

Martin EFX800 Manual do Utilizador Página 19