Martin MiniMAC Maestro Manual do Utilizador descarregar pdf (Página 48)

48 Preparing a fixture for DMX control

“tracks.” The Exterior 600 has a digital filter algorithm that averages

several updates to ensure smooth movement.

• Vector control provides a way to program fades on controllers without

programmable fade times or cross-faders. With vector control, instead of

breaking up the movement into many small positions, the controller

sends one position value along with a speed value that is programmed

on a separate channel. Vector control may provide smoother fades than

tracking control with some controllers, particularly on very slow fades.

Using DMX mode 2 you are able to switch between tracking and vector

control, but you cannot use both at the same time.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 83 84

Exterior 600 1
Introduction 6
Software note 7
Safety information 7
Lamp safety 8
Introduction 9 9
Installation 10
Fastener spacing and type 11
Adjusting pan and tilt 12
AC power 13
Prerequisites 14
Replacing the power cable 14
AC power 15 15
16 AC power 16
AC power 17 17
Data link 18
Adaptors 19
Building a data link 20
Fixture settings 21
22 Fixture settings 22
Fixture settings 23 23
Fixture settings 25 25
General operation 26
General operation 27 27
Table 1: LED status messages 27
Fixture control methods 28
General operation 29 29
30 General operation 30
OPERATION 31
Stand-Alone 32
About scene timing 33
Programming methods 34
Programming from a 35
PC using MUM 35
Stand-Alone Settings 36
Setting a light-level trigger 37
Setting a timer trigger 37
Programming effects in scenes 38
Scene management 39
Stand-Alone show 41
42 Stand-Alone show playback 42
Synchronous 43
3. DMX 45
Preparing a fixture 46
DMX lamp off option 47
DMX reset option 47
DMX mode 47
DMX controller 49
Effect operation 50
Lamp off 51
Color wheel 51
CMY subtractive color mixing 51
Random color mixing 52
Beam shaper and frost 53
DMX protocol 54
DMX protocol 55 55
56 DMX protocol 56
TROUBLESHOOTING 57
Seal maintenance 58
Cable glands 59
Cleaning 60
Firmware updates 61
62 Firmware updates 62
Firmware updates 63 63
Lamp maintenance 64
Lamp maintenance 65 65
Installing the lamp 66
Lamp maintenance 67 67
68 Lamp maintenance 68
Maintaining the 69
Main fuse 70
Fuses on the PCB 70
Changing the power settings 71
Troubleshooting 75
76 Troubleshooting 76
EFERENCE 77
PCB layout 78
Exterior 600 specifications 79
*Calculated 80
Accessories 81
Related items 81
Spare parts 81
Ordering information 81
Tel: +45 8740 0000 • 84
Fax +45 8740 0010 84

Comentários a estes Manuais

Sem comentários

Martin MiniMAC Maestro Manual do Utilizador Página 48

Comentários a estes Manuais