Martin MiniMAC Maestro Manual do Utilizador descarregar pdf (Página 47)

Preparing a fixture for DMX control 47

control channels to receive instructions from a controller. The Exterior 600

uses eight (mode 1) or nine (mode 2) channels of control data. When

operating in mode 1, the fixture reads the data on the start channel and the

next seven channels. If the control address is set to 100, the fixture uses

channels 100, 101, 102, 103, 104, 105, 106, and 107. Channel 108 would

be the control address for the next fixture.

If two or more fixtures are set up with the same address, they will receive

the same instructions and should behave identically. Setting up identical

fixtures with the same address is a good tool for troubleshooting

unexpected behavior and an easy way to achieve synchronized action.

To set the DMX address use the DMX Address spin button. The fixture

address is updated in real time.

DMX lamp off option

When the DMX Lamp-off personality is on (the default setting), lamp power

can be turned off from the controller by setting channel 1 to a decimal value

from 248 to 255. When set to off, the lamp-off command executes only if

channels 3, 4, and 5 are set to values from 230 to 232.

DMX reset option

When the DMX Reset personality is on (the default setting), the fixture can

be reset from the controller by setting channel 1 to a decimal value from 208

to 217. When set to off, the reset command executes only if channels 3, 4,

and 5 are set to values from 230 to 232.

DMX mode

The Exterior 600 has two DMX modes of operation:

The speed at which effects fade, that is, move from one position to another,

can be controlled in two ways known as tracking control and vector control:

•With tracking control, fades are programmed using the controller’s fade

time. The controller divides the fade into small pieces that the fixture

Mode 1 Use 8 DMX channels and provides tracking

control of the fixture.

Mode 2 Uses 9 DMX channels and provides both

tracking and vector control. (Recommended)

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 83 84

Sem comentários

Martin MiniMAC Maestro Manual do Utilizador Página 47